The spindle is made of a high- tech ceramic or stainless steel and the bearing is made of PEEK or ceramic. This paddle wheel consists of stainless steel with very low ferromagnetic characteristic. Stainless steel paddle wheel flowmeter with inductive detection and pulse output This flowmeter allows for Indication, monitoring, transmitting and On/Off control – all in one device. The type 8039 paddle flowmeter has an extra-large display and is specially designed to switch a valve and to establish a monitoring system or an On/Off control loop. This optical method allows the flow rate to be detected in media with ferromagnetic particles and to detect the direction of the flow. The rotation of the paddle wheel is detected with these IR diodes and the integrated electronics converts the reflected IR-Signal to a square wave frequency signal, proportional to the flow rate. Two infrared transmitters (IR) and receivers are placed in the electronics housing outside of the medium area, separated by plastic which allows infrared radiation to pass through it. The paddle wheel is made of PVDF material and the spindle and two bearings are made of wear-resistant ceramic material (Al2O3). Plastic paddle wheel flowmeter with optical detection and pulse output The flowmeter is available in 2 measuring principles a magnetic measuring version and an optic measuring version which allows infra-red to be passed for use with liquids. The type 8012 paddle wheel flowmeter is used for continuous flow measurement and is especially designed for use in neutral, slightly aggressive, solid free liquids. A connected, battery operated display unit allows operation independent of mains voltage. This sensor is two-wire and requires no additional auxiliary energy supply. The rotation of the paddle wheel generates a sinusoidal voltage signal in the coil proportional to the flow rate. The frequency and voltage change in proportion to the rotational speed of the paddle wheel and two positive signals are generated per revolution. A coil with a ferrite core, detecting the magnetic field of the rotating paddle wheel, is placed outside of the fluid area. Plastic paddle wheel flowmeter with inductive detection and sinusoidal outputĪ PVDF or PP paddle wheel with four molded permanent magnets in the arms rotates on a precision, wear resistant ceramic spindle and two ceramic bearings. The Type 8011 Paddle Wheel flowmeter is for continuous flow measurement and is especially designed for use in neutral, slightly aggressive, solid free liquids. An integrated electronics board converts this signal to a square-wave frequency signal. Two output signals are generated per revolution and the frequency changes proportionally with the speed of rotation of the paddle wheel. A Hall sensor detects the magnetic field of the rotating paddle wheel is placed outside of the fluid area. Different types of Paddle wheel flowmeters Plastic paddle wheel flowmeter with inductive detection and pulse outputĪ PVDF or PP paddle wheel with four moulded permanent magnets in the arms rotates on a precision, wear resistant ceramic spindle and two ceramic bearings. This results in the different paddle wheel sensors the measuring principles of these paddle wheel sensors will be described below. Paddle wheel flowmeters may be differentiated by the material used for the paddle wheel (plastic or stainless steel) or on the basis of signal detection/evaluation (coil sensor, HT coil sensor, Hall sensor or optical sensor). Experts in Flow measurement, Bürkert, provide us with technical explanations of how the different types of paddle wheel flow meters operate and also which applications these different types of flow meters are suited to. This article will look in detail at the Paddle Wheel measuring principle for flow measurement and control.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |